ADURO 7 Manuel d'utilisateur télécharger pdf (Page 6)

- 6 -

In order to obtain the best possible combustion, you should regulate the effect/heat output with the fuel.

Burning small logs provides more powerful combustion than burning large logs as the surface area is greater

and more gas is released. The amount of wood in the combustion chamber is another factor that affects

combustion. In normal circumstances, you should not place more than two logs in the stove. If you want an

enhanced effect, you can add more logs. The nominal heat output is reached by burning approx. 2.2 kg per

hour.

3.6 Secondary damper

The secondary damper behind the door should always be open while the wood burning stove is in use. This

damper allows you to adjust the wood burning stove to the chimney draft and the heat output you require. In

normal circumstances, the wood burning stove should be working with this damper open between 60 % and

100 %. You should never close the air intake so far that the flames are extinguished. There should always be

visible flames in order to achieve clean and efficient combustion.

Aduro Key: provides easier control of the secondary damper. The key is fitted onto

the control handle, so you can more easily adjust the airflow from side to side. Turning

to the left decreases the airflow, and turning to the right increases the airflow. When

the key is not in use, it can hang on the edge of the drawer.

3.7 Primary damper

When you add a new log, the primary air intake/damper should be opened until the fire is burning properly. In

order to utilize the fuel to the fullest extent, the embers should have burnt for so long that it is necessary to

open the primary air intake for approx. 2 minutes to get the new log to burn.

In order to reduce the risk of ash falling from the stove when the door is opened to add more fuel, it is a good

idea to open the primary air intake/damper for approx. 1 minute before the door is opened. This increases

the draught through the stove and reduces the risk that ash will drop on the floor.

Please note: if you overload the wood burning stove and burn more than approx. 3.4 kg wood/hour, there is

a risk that the lacquered surface of the stove will become discoloured and eventually fall off. The stove can

be resurfaced, but this is not covered by the manufacturer’s guarantee. In the same way, any other damage

to the stove caused by overloading will not be covered by the guarantee.

3.8 Aduro-tronic

The patent-applied Aduro-tronic is designed to operate the stove for you. All you have to

do is put dry wood in the stove, and activate the control system - Aduro-tronic does the

rest, leaving you to enjoy the flames and the benefits of efficient combustion. Aduro-tronic

is a patent-applied mechanical solution, which works without the use of electricity.

Please note: Use of dry wood of the right size is important to achieve optimum

combustion.

3.8.1 How to operate Aduro-tronic

When lighting

When lighting a fire in the wood burning stove for the first

time, the maximum amount of primary air will be needed to

light the fire. For that reason, the primary damper can be

kept “forcibly open”. This is done by pulling the primary

damper forward as far as possible and then fixing it with the

Aduro Key (see illustration). When the stove is warm and a

layer of embers has been created on the bottom of the

combustion chamber, the Aduro-tronic can be set to the

automatic position, i.e. the Aduro Key can be removed.

Alternatively, you can leave the door ajar the first minutes

during lighting the fire (without the key).

Aduro Key

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

ADURO 7 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers ADURO 7